Rena T-650 User Manual download pdf (Page 11)

GETTING ACQUAINTED

Tabber Control Panel

127 6 8 9 11 5

*Transport Power Switch – Turns the tabber transport power ON.

LCD Display – Keeps the operator informed of the status of the tabber.

Soft Keys – The soft keys are used to step through the various menu options.

Measuring Scale – Use the scale to measure media length, tab position and tab pitch.

Speed Control Dial – Adjusts the speed of the tabber transport.

NOTE: The maximum speed of the T-650 is determined by number of tabs being applied.

Up to 25,000 pieces per hour when applying a single tab to one side of the media.

Up to 15,000 pieces per hour when applying two tabs to one side of the media.

Up to 10,000 pieces per hour when applying three tabs to one side of the media.

Exceeding these speeds will cause the tabber to stop.

Stop Key – Pressing this key will cause the tabber to stop, after it has finished tabbing

and clearing all media from the tabber. “Wait” is displayed during this process.

Run Key – Press this key to start the tabber and run the job.

Info Key – Provides additional information about the menu item you are viewing.

Save Key – This key is used to save entries into memory.

10.

Key Pad – Used to set the adjustments and program the tabber.

11.

Clear Key – This key will clear any incorrect entry before it is saved into memory.

12.

Emergency Stop – Pressing this button will immediately stop the tabber (turns off

transport power) and will stop any devices connected to the Emergency Stop (Safety

Stop) circuit. Turn button clockwise to release (reset) it.

*Transport power will not activate unless all safety and emergency stop circuits are closed.

T-650 Operations REV. 8/25/2010 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 117 118

No comments

Rena T-650 User Manual Page 11